(Please note that the photos here do not feature the tunnel.)
The most impressive engineering feat by any western railroad in conquering the Cascade Mountain range to reach Seattle, Washington was the Milwaukee Road's Snoqualmie Pass Tunnel. The tunnel, the longest on the entire railroad at well over two miles in length, was not opened until more than five years after the original route commenced operations resulting in the railroad using a steep and tortuous temporary right of way over Snoqualmie Pass. The tunnel's impressiveness, however, was because of its short length and low grade resulting in very efficient train operations (much more efficient than nearby Cascade Tunnel). Today, however, the best engineered tunnel over the Cascade Mountains lies dormant and has not seen a train in more than 30 years (the tunnel is part of the John Wayne Pioneer Trail but has been closed since early 2009 needing millions in maintenance repairs).
Few rail lines, let alone railroads, have garnered such interest, intrigue, and awe as the Chicago, Milwaukee, St. Paul & Pacific Railroad's Pacific Coast Extension, even 30 years since it was abandoned. Unfortunately, the best engineered rail line through the rugged Cascades could not save it from the inept decision making of management at the time and it is now but weeds and trails, a vital transportation artery no longer available to shippers and the American economy.
In 1901 the first surveying work began and it was estimated the more than 1,400-mile western extension would cost the railroad around $45 million adding more than 25% to its total system mileage. However, four years later this number was readjusted to $60 million. What made the extension so terribly expensive was partly due to the right-of-way costs. Unlike the Great Northern and Northern Pacific the CM&StP was not given free government land grants and had to both purchase all of its land from private landowners as well as take over a number of small, new, or floundering railroads across the region.
Amazingly, in just three short years the entire extension had been completed and on May 19, 1909 a Golden Spike was driven at Garrison, Montana commemorating the opening of the new route. The Milwaukee Road's Snoqualmie tunnel lies in western Washington about 55 miles east of Seattle. It was one of the final tunnels the railroad had to construct although it was also the longest and took two years to complete. The pass lay along the railroad's final stretch of its Pacific Coast Extension covering just over 330 miles from the Idaho/Washington state line to port city of Seattle. The railroad would break down the Washington state portion of its main line into four divisions; the Idaho Division (which also included the route through Idaho), the Eastern Washington Division, the Yakima Division (in which the tunnel was located), and finally the Coast Division.
Surveying work for the route across Washington state began officially in October, 1905 with crews laying out three different lines. In total, the crews surveyed some 1,655 route miles while just 300 miles actually spanned the distance between the Idaho/Washington state line and Maple Valley, Washington (from here the Milwaukee Road would connect with the Columbia & Puget Sound Railway to reach downtown Seattle). Broken down crews surveyed roughly 5.5 miles of right-of-way for every one mile ultimately chosen as part of the main line.
Construction through Washington state began in late May, 1906 with the principle contractor being H. C. Henry, who sub-contracted out various stages of the building to other companies. By early 1909 the route was complete and open through the state, although several years of construction work remained to get the line up to par, such as the completion of Snoqualmie Pass Tunnel. The delay to build the tunnel was the result of its remote location. To better facilitate moving goods and supplies to the site upon construction the railroad elected to first complete a temporary line over the pass.
Since construction on the tunnel did not begin until 1912 the bulk of the work on the structure was actually done by the Milwaukee Road itself and not outside contractors. The tunnel took two years to complete, opening in 1914, spanning a distance of 11,890 feet or 2.25 miles. Of note, the structure was setup to eventually be double-tracked although this never occurred (thus the use of dual portals on the western slope). The tunnel was immediately prepped for electric operation, which commenced shortly after its opening. Overall, the ruling grade on the route between Cedar Falls and Rockdale, up to the tunnel's western portal is 1.7% with the tunnel itself level. From Cle Elum up to Hyak at the tunnel's eastern portal the grade is even easier being just 0.7% (in comparison, before the tunnel was completed grades over the pass were 2.2% up the mountain's eastern slope and 2.75% along its western slope).
To compare this with the nearby "new" Cascade Tunnel (the second structure to span Stevens Pass), hailed as an engineering marvel of its day when completed in 1929 it is a daunting 7.8 miles in length more than three times longer than the Snoqualmie Pass Tunnel. This extraordinarily long tunnel resulted in builder Great Northern constantly fighting fumigation issues after it de-electrified the route in the 1950s and even today, owner BNSF Railway has similar issues requiring ventilation fans to be in operation on a daily basis and trains must wait for the air inside to be cleared before operating through.
Snoqualmie Tunnel never had this issue, even after electrified
operations ended in 1971 along the Coast Division (Othello to Seattle)
due to its relatively short length.
In terms of grades, Cascade Tunnel is not level inside like Snoqualmie,
featuring a 1.7% grade. Also, grades are over 2% leading to the tunnel
along the eastern and western slopes, much steeper than at Snoqualmie Pass. Interestingly, Burlington Northern purchased the tunnel and a section of the line through Washington
state after the Milwaukee Road abandoned operations in 1980 but why the
railroad never decided to use the route to reduce maintenance costs and
operating times remains a mystery.
Check out the website's digital book (E-book), An Atlas To Classic Short Lines, which features system maps and a brief background of 46 different historic railroads. To learn more please click on the image below.